Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi -Can someone help me getting started (if at all possible...) with enabling controll of used bandwidth at a "per-user"-level.I wonder if it possible to do this dynamicly with respect to the overall demand from other users.I've searching a lot, but ...
Hi -I'm trying to configure two Aironet 2602e (with external antennas) to form a bridge between two buildings. I can't figure out how to get them to run faster than 54 Mbit between them. Currently they just sit at my desk in a test-setup. I think, I ...
Hi Joseph -Thank you for the idea - I will investigate very soon.Do you not think, it's possible through either SRR (Shared Round Robin) or (Shaped Round Robin) to achieve some of the "limiting"?Sincerly Nicholas
adantu, I'm reading away on that link I can see, it will help me get some limiting so that one single user cannot take it all, but I hoped there was some feature that could enable to "share" the bandwidth in equal portions, with respect to the numbe...
Hi again -Now it works with the commands you gave - I gave the non-root a little time to adjust to the root, which had 40-above, and the non-root adjusted to 40 MHz. Super.Now I'm in doubt if I'm getting enough out of my MIMO-antenna - is the AP self...
Yes - The association happened, but the non-root kept showing 20 MHz and I couldn't transfer a file with more than 0.6 MByte pr. sec. I changed root-AP back to 20 MHz and it went back to normal (which is approx 50 Mbit/s - the AP's are now positioned...
Hi Rasika -On my root-AP I can issue the channel-command but on the non-root it doesn't recognize "channel"----Gangbro3-slave-kirke(config-if)#channel ?% Unrecognized commandGangbro3-slave-kirke(config-if)#channel----There seems to be endless questio...
