Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our company has a cisco 2911 for edge router .
It's version
c2900-universalk9-mz.SPA.150-1.M5.bin.
It only has
nat, default route and some access-list
for it, .recently it occasionally crash, about once / two months.
could some help have a look at ...
I got a cisco 2911 router with ios version Version 15.0(1)M5.It have ipbasek9 and securityk9 license.ipbase ipbasek9 Permanent ipbasek9security securityk9 Permanent securityk9 i want konw that can it use IOS integrated ips...
I have a cisco1841 router with 32M CF card installed.Now , i want boot a system image larger 32M from usbdisk.First i insert the 128M usb flash disk to the 1841 router and format it, then i can see the device from dir command.Second copy the larger ...
there's a question confused me.when a packet in or out an interface . What sequence will used.Nat、ACL and Routing table?Does someone can tell me .thanks.
I have a cisco 1841 router , and i want to configure zone based firewall on it.But the document of zone based firewall only said that "after 12.4(6)T" can support zone based firewall.I use the ios " c1841-ipbasek9-mz.124-15.T9.bin ", but it can't s...
I have test that ， the 1841 router can boot from usb disk。but there is a problem that when the router reload.before the second " program load complete.........................."there is about 3 minutes to wait.So , the router boot from usb disk take ...
