Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
Currently I am running 2 routers (routerA and routerB) which connected to a Nexus switch and using static routes.
Manual add
ip route 192.168.0.0 255.255.255.0 192.168.123.2 (If routerB down)
or
ip route 192.168.0.0 255.255.255.0 19...
Currently I am configure a bgp between 2 ASAs. Attached is my diagram.
I have a problem, I did configured my ASA-A interface with 10.64.150.8/25 and ASA-B interface with 10.64.150.1/25 and able to ping each other.
When I want to advertise network ...
Hi,
I have a vlan (172.16.1.0/24) configure in Cisco ASA. How to block the same vlan access in Cisco ASA. Or it should be configure an ACL within the switch?
Example.
I want to block access from PC1 to PC2.
PC1(172.16.1.63) - SwitchA-gi01 - Cisc...
Hi,
I have DMZ(Web Servers) and Public , 2 interfaces in Cisco ASA-X. The ARP default timeout in ASA is 14400 seconds (4 hours). My web servers running in virtual machine. 1 of the machine shutdown and it not able to failover to another machine is...
Hi,
Appreciate if someone can help to pinpoint what is my error when I configure 2 static routes in 2 routers for redundancy. But I can't failover to each other until I need to remove and re-add the route.
I have 2 routers 2901 routers and connect...
Hi Richard,
10.64.151.0/25 is a network not exist in routing table and use as NAT purpose. Agreed with you that the BGP route won't show up 10.64.151.0/25 if it not configure on any interface and no static route.
