Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are looking to replace both our Catalyst 6513 with two new Catalyst 4510RE. I was looking for some documentation, on the best process to migrate, with minimal down time, but can't get my hands on anything. Can somebody suggest any good documents...
Hi,We currently have Nexus 1000v and some ESX hosts deployed on our internal private network. We currently have a single ESX host deployed in our DMZ. Is it possible to manage the ESX Host in the DMZ with the Nexus implementation in our internal pri...
Hi,When doing a show interface on an port on my Catalyt 3750, I gave a line that states "Media-Type configured as connector".....What does this mean? And can this affect the end device connecting to this interface?Thanks.
Hi,I’m running vCenter 4.1 and Nexus 1000v and about 30 ESX Hosts.I’m using one system uplink port profile for all 30 ESX Host; On each of the ESX host I have 2 NICs going to a Catalyst 3750 switch stack (Switch A), and another 2 NICs going to anothe...
Hi,I'm using Nexus 1000v and vSphere 5.1;I just migrated some physical servers to VM, and I have some weird reporting issues;Just to make sure it wasn't a network issue they asked me to verify if anything was overlooked on the Nexus side of things;E...
Joe, Thanks for your reply. To elaborate on the the setup I want to accomplish....Presently I have vCenter and VSM in my private network. I have a single ESX host in my DMZ. I want to manage this single ESX host from my VSM/vCenter which are in my...
Hi,I'm not using MAC Pinning;Here is the VSM uplink PP configs:port-profile type ethernet uplinkport-profile type ethernet name-uplink vmware port-group mtu 1500 switchport mode trunk switchport trunk allowed vlan 1,988-989 switchport trunk nat...
I would like to use LACP port channel instead of a static port channel, because LACP will shut down a link in case of a faulty nic (dead, driver issue, etc), instead of trying to send traffic through that link. With static port channel, one side go...
Thank you for all this great info; I appreciate your help!So here is what I currently have configured on my VSM and Cisco 3750 stack, and i've underline the commandes that need to be added to enable lacp offload, can you confirm if this is what I nee...
Thank you for the explanation; I do have vsphere 5.1 and nexus 1000v.So with LACP, if the NIC fails for any reason, the interface in that LACP port channel will go in an err-disable mode, correct?Also, I read a document stating that LACP should be c...
