Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I'm a beginner in the world of wireless, and I wonder if in a WLC 2125, I need to configure a physical port to the AP Manager or just need to configure the AP Management and AP Manager will automatically accept.I am awaiting response,...
The problem is some fiber or UTP cable, it is fact!! you need to check if there is any problem between switches that connect to the server (if I understand correctly, you have a switch to the server ..)
@Dinesh, please send the following command: Cores# sh run interfaces gigabitEthernet 1/33Cores# sh interfaces gigabitEthernet 1/33 switchport TksEduardo
@Johartman, What type the Switch (4500 or 6500) did u have? But if you look on the Cisco website, you will see that almost all accept redudant power supplies intro Chassis
Hi Dinesh, Your port probably has some security setting, like as port security or something of the genre...as said pddriver, please send the configuration of ports for better analisys!!!TksEduardo
Dear Amro, You checked if your supervisor is not problems with high processing? The "fans" in power supply is operating normally?Please check processing using the command:sh processes cpu history And then check if the processing is normal then check ...
