About z

06-09-2017

I am setting up my first Cisco Switch, its a 3560G and I'm going to use it to segment my network with Vlans, I have followed this guide. All I have connected right now is my router (cheap Home router) and I can ping devices on my local network 192.1...

06-10-2017

I'm not using a cisco router but I believe I have routes set up properly in my Home Router, I have static routes pointing all the 10. networks to the router-switch interface. I am able to ping from a device connected right to the router to a device...

06-09-2017

Alright so I messed up bad here, I had my router access control on so that new devices were blocked, after turning that off and allowing the blocked devices (switch and laptop currently) I am able to ping the router. I also changed the route to ip ...

06-09-2017

I leave work in half an hour, I'll let you know.

06-09-2017

So you are saying I should use int g0/24 as the next hop? Sorry for all the confusion, I'm learning Networking basics at the same time as I'm learning the Cisco IOS.

06-09-2017

I'm sorry, I'm trying to follow along, this my first experience with a layer 3 switch, or Cisco in general. Say I ping 8.8.8.8 it would be required that it goes through my router as that is the only device with public facing interface. Without a sta...

Member Since	‎06-08-2017 03:18 PM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	9

User Statistics

User Activity

setting up switch 3560G

I'm not using a cisco router

Alright so I messed up bad

I leave work in half an hour,

So you are saying I should

I'm sorry, I'm trying to