Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been stuck with Fortigates for awhile and had to help a customer with their ASA setup.
They state that Guest interface can reach inside hosts/servers.. And when I check, I see that we have no NAT statement between Guest and Inside networks.
...
Hi Question, I got a Cisco 5510 with 3 interfaces InsideDMZ1DMZ2 I have a DHCP server on "Inside" and I want to relay DHCP request from both DMZ to this inside interface...But when I try, I only get to enable relay on 1? What I did:dhcprelay server d...
HiIs there a way to get SNMP forwards for AP's going up/down to a NMS station from cisco prime 2.0?We are using OP5 as NMS and it would be very sweet if we could get dynamic AP events to OP5 from Cisco Prime.Or, should we just let controllers snmp tr...
Hello all.My company is looking to invest into a supplier of wifi survey tools.I have used airmagnet survey pro and I like it.. But it is rather expensive.My collegue then found netspot, it's for Mac OS only, I did a fast trial of it of it and perfor...
Hello everyoneRunning vwlc 7.3.101 and encountered a smaller issue.When you enable / disable a SSID, all AP's reset their radio interfaces... causing everyone to drop their connection.Is this intentional?Thanks
Fast answer! Appreciated! Follow up question/clarification I do not have to think about different security levels then? I only need NAT when I want do to do PAT/change IP addresses instead of the original IP's? Thanks
Alright.. think I solved it. I created another interface.. which was able to use dhcp relay.. So I deletede dmz2, wrote config and re-created it.. now it works suddenly will test with users and see if it actually works or not
I have removed the configuration, wrote the config and tried again.. doesnt work Tried in ASDM [OK] dhcprelay enable dmz1[OK] dhcprelay setroute dmz1[ERROR] dhcprelay enable dmz2Command failed[OK] dhcprelay setroute dmz2[OK] dhcprelay server dhcpserv...
hi Akshay, I never tested to try and save config..In CLi it takes the command and just removed the old one and uses the new cli command. If I try this in ASDM i actually get an error (when checking both interfaces for an relay) that one of the inter...
