Radio resets when enabling new SSID

[azore2007]

Hello everyone

Running vwlc 7.3.101 and encountered a smaller issue.

When you enable / disable a SSID, all AP's reset their radio interfaces... causing everyone to drop their connection.

Is this intentional?

Thanks

[Scott Fella]

I have never ran into that issue at all. I make changes to specific eland and that doesn't affect any other wlans nor does it glitches the ap radios.

I do this all the time too.

Sent from Cisco Technical Support iPhone App

[maldehne]

APs shouldn't rest their radios upon enabling or disabling ssid from WLC.

If the AP is autonomous , then adding or removing SSID to-from the radio interface causes it reset.

attach show run-config

highlight the APs that had resetted.

---------------------------------------------------------------------------

Please Don't to rate correct answers

[azore2007]

Yeap, thats what I thought, couldnt remember having the AP's resetting their interfaces when enable/disable SSID'n

I will open a TAC case

I'll post the solution when I get it

Thanks for the replies

[Stephen Rodriguez]

Clarification question.  Are you using AP groups?

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered