Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am looking into configuring Dynamic ARP Inspection and DHCP snooping on my network. While the configuration is pretty straight forward, I am not finding much information in regards to wireless deployments. My networks utilizes a single vla...
Hello I'm new to EEM scripting. My ultimate goal is to design a script that will shutdown switchports that are connected to wireless access points, and then a few hours later turn them back on. I've tried combining a shutdown script and also a CDP ...
With Arie's script I still lose all Cisco connected ports not just the ones connected to wireless access points. Additionally, as soon as the port is reenabled it goes down again. I want the script to deploy once per day at a specific time. Is thi...
I'm finding that when I use the various cdp functions it will affects all ports connected to a Cisco devices rather than just access point. One variation is below. I've also tried defining the capability string and platform. Everything will either...
Thank you both for the advice. I'm still a little confused on how to tie your recommendations into my original script. I've read through some of the Cisco EEM documentation, but find it is pretty hard to make sense of. Does anyone know of a simila...
