Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I have different configuration files saved in flash. I am having issues replacing the current running-configuration file using the command configure replace flash:<name of file>. It sometimes
works but I am seeing issues were the curre...
Hello,
I have read that vlan 1 should now not be used as the management vlan. So on a 3560x switch I have made an attempt to move it to another vlan. I want to keep the same IP address, just move it.
From the switch to a Linux terminal I edited a co...
Hello,
I have several different configuration files saved in flash. I want to be able to pick any and load it as the running-config file.I have attempted to use the command: configure replace flash:<name of file>. I receive rollback abortion message...
Hello All,Could use some help. I am looking at using EtherChannel to route multicast data from a source to a destiantion unit. I wouldlike to try using L3 instead of L2 using two 3560x switches. I have made several attempts to get data to the end ...
Hello AllI use the 3560X model and I have a question.Would I be able to save multiple run config files, allowng me to be able to select the desired one, instead of having to rewrite the configuration.that I want to use.Thanks.Regards,Jeff
Hi Richard,
I found something out on my quest to get this function to work. I cannot explain why it works but
this is what I have. I have two configurations that are saved in flash. Both configurations are different
in their operations. The first ...
Hi Richard,
I have three 3560x switches that are currently active. On the first switch after I enter the command, the running-configuration file is replaced successfully from flash. The message states:
Total number of passes:2Rollback done
Show r...
Hi gpauwen,
It is rather simple but it took some time to get here:
copy flash:/<config file> startup-configreload
What this did is it took a configuration file that I edited under Slackware that changed the management vlan to 100 but kept the origina...
Hi Leo,
I have enclosed two attachments. The first attachment (config_test) is a copy of the running-config file in the switch at this time. Also included in this is the failure messages of attempting to load another config file as the running-conf...
