Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I need help on Leaf switch interface configuration shifting from one Switch to other Switch.My environment was running with DNA SD Fabric for campus and ACI Fabric was DC.3 APIC in Single cluster connected with 6 Leaf Switches 1 APIC with tw...
Some one provide some good document to configure the IPSec Tunnel in ACI Fabric to test one issue.We have Site A with 10G connection P2P connection to Site BSite B have P2P connection to site A and MPLS connection to Site C.Now we have our Storage ac...
Hi All,How to see what are Networks configured for each VLAN in ACI, I am not see the Network details in ACI, I explored to see that under BD but dont see any details it was showing some Querier IP address under all BD which was unreachable.I am new...
Hi All
I am not able to login one device initially . Device is reachable and even i am getting login window. But i am typing by username its take minimum 10 Seconds(dineshkumarmariappan) to feed my username getting error as serv...
We had one Branch office and one head office. Each location we had 2 Routers(Primary and secondary) configured with EIGRP. Recently we implemented IPsec for the traffic. EIGRP route will take place in primary only. if i configured variance comman...
Thanks for your time to explain much detail.I mentioned 6 Logical Interface profile that was not rightUnder L3_out There are 6 Logical Interface profile configured towards firewall.under each Logical Interface Profile there 2 IP configuredLet Say Sid...
Addition to above i can see one of the config done under management interface with broadcast storm control level 4 command. Even My session terminated in 5 Seconds. So i am suspecting this command might be the reason is my understanding was correct?
EIGRP was configured on both routers and IPsec also configured both router.. IPsec was configured WAN Peer IP of Branch is configured in head office and vice versa.. There is connection between Primary and Secondary router... Right now only one rou...
why we using 255 , why cant use 300,400 ,500 so on.. what is 255 denotes.. 1/255 for tx load and 1/255 for rx load.. how u can it was reliable what is mean by it.. could explain it.. 3. ipsec also wont support in L3 swicth
