Hello,
I was facing the same issue and the "neighbor <neighbor-ip> prefix-length-size 2" command solved it.
(GNS3 with IOS XE and IOS XR.)
Thanks and best regards,
Hello Xander,
In case i want to enable the MSS adjustment on a GRE tunnel, the procedure would be to configure the MSS on all the NP that the tunnel could, potentially, use to reach the tunnel destination?
Thanks,
Marlon
Basically it refer to the network that provide the transport from the access to the core. Nowadays this network is usually an IP/MPLS network.
In LTE, for example, is the one that communicate the eNodeB with the MME/Gateways.
I'm going to schedule the SP installation and i'll let you know.Apparently is not a SVD issue cause the SVD state is "unsupported" and the role is "standard" so i believe is not enabled. I've configured a subinterface for the Imp-VRF vrf on the LC 0 ...
Hi Xander,In the previous table i made a mistake with the outputs. The second router outputs were from a ASR9001 from which i have the same behavior. The comparison chart from the two ASR9010 looks exactly the same as the previous one excepting the l...
