Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I wish to disable the three guest SSIDs that were preconfigured and enabled on my EPC2425. I am concerned that - having spent time and effort setting up a secure primary SSID - there are three open SSIDs allowing anyone to access my residential g...
Thanks Eric and Cindy. I restored factory settings and guest access is still enabled. Though two of the guest SSIDs show as Open - no security - I could not connect to them. I have restricted WiFi access to my devices only using an allow MAC list.Tha...
Hello Eric,In the meantime – until a solution can be found – I have decided to restrict WiFi access to my devices only, by entering the MAC addresses of my devices in the Setup > Wireless > Access Control > “Allow Access List”. Hopefully that will pr...
Hello Eric,Thank you for helping out with the problem.The Signal tab only shows the state of the cable signal – the upstream and downstream channels. However at this time I’m not using the EPC2425 as a cable modem. I’m using a new TC7200 as the cable...
Hello Eric,Sorry I posted in the wrong forum area. A person from Linksys said I should post here.I do not know who configured the guest SSIDs. Its possible guest access may have been enabled when my modem/router was initially installed possibly using...
Hi Harvinder,I tried your link but the page was not found. Some related links were shown and I followed these. They related to Guest SSIDs and the use of Cisco's Command Level Interface which technical people may use to setup/configure Access Points ...
