Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we are running some 3750x´s switches as an access device for VoIP phones and PC´s. Lately we are having some issues conecting IP phones as we can see that the port links up (we can see the led blinking) but if we issue the "show ip int brief" to ...
Hi, I´m installing a Wifi solution using Cisco 2504 Controller, 1602 AP´s connected to switches using a SG200-08. Am not sure the config for the port on the switch (Cisco 2960). Both ports (the one that connect to the wifi controller and the one that...
What else... You helped me and I helped you. I have read a lot about the bugs the version has but, so far, no problem has been detected on our CPU loads.Again, thank you very much for helping us.
Hi Leo, as you guessed pretty well, there was nothing connected but the command you showed us was very helpful cause we could determine that where wire was faulty. Also we could see that it happends on several customer worktable.Thank you very much d...
The configuration of the SG200 is as follows:Ports 1 to 5 as access for APPorts 6-7 as access for managementPort 7 as trunk for carrying all vlansCannot access the 2960 but the config made is as follows (from my mind):gi 2/0/34 (connected to SG200)sw...
