Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a WLC2504 with 10 licenses running 8.5.151.0.I have several 3602 AP's with AC radio module that previously could join the controller, but now don't join the controller anymore. As reason for the failed join attempt I read: Missing AP Man...
Thank you for the link. Unfortunately I cannot download the software (I am logged in, but have no active subscription). I wonder if this could qualify as a free update because of a security vulnerability?
Hello Rich,Thanks for your helpful addition. I think I should update the software to 8.5.182.7 to be sure all will continue to work. How can I obtain 8.5.182.7 - I don't have an active software license, nor do I see it listed on the downloads.Kind r...
Thank you so much for your help. Will there be a software update made available in which these certificates have been renewed?Kind regards,Niels van Strien
Hi again - it was a while since I used the CLI over serial but I managed to connect and issue both commands:config ap cert-expiry-ignore mic enableconfig ipv6 disableand then saved the configuration, performed a reboot. The access points that previou...
Ok disabled and rebooted the wlc2504. The message log now says the info below.The config ap cert-expiry-ignore mic enable command can only be issued when connected directly to the wlc via CLI, correct?Thanks,Niels Message Uploaded at Jan 24 15:52:14....
