Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I am setting up a CME using dual registrations. With the generous help of people on this forum I have gotten the dual registrations to work. But now I need to know how to set up the dial-peer to use the registration information. For exam...
Hello,I'm trying to pass a SIP INFO message on an NG911 call with "Content-Type: application/rfai-bridge-request+xml". The CUBE replies with "Unsupported Media Type". I have enabled the pass through configs I know to use. Does anyone here have any...
I am trying to replace a competitor’s product with a Cisco 2921. The current product is a SIP to CAMA gateway, where calls come in SIP and go out FXO CAMA to a destination. The destination can perform two subsequent polarity reversals (mid-call wink)...
Hello,I've got some expierience with the CUBE, but now I'm setting up a proof of concept where it's SIP to FXS. I'm new to FXS.Nothing fancy, a SIP call comes into the 2921 with FXS, the dial peer routes to the FXS voice card port, the analog phone ...
Thanks for the quick reply Kevin.My concern with using the two dial-peers and specific IP addresses is that if one of the trunks is down, there will always be a post dial delay while the CME fails over to the next dial-peer, correct? I was hoping to...
Thank you for the reply. Here is the call sequence along with the full config:Jan 23 20:11:09.177: //-1/xxxxxxxxxxxx/SIP/Msg/ccsipDisplayMsg:Received: INVITE sip:911010501@10.182.27.210:5060 SIP/2.0Via: SIP/2.0/UDP 10.182.27.228:5062;branch=z9hG4bK...
