Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, is it possible to get information from Firepower 1140 device with Cisco ASA image to Cisco CSP Collector? When I do it via standard procedure of SNMP pull from ASA - it wont return any Serial Number - just basic info. I suspect it will be sam...
Hello, We have a CSP collector (version 2.8.16) and we are trying to discover APs which are connected to WLC. In a older discussion I read that its enough to add WLC and APs will be discovered automatically. But seems its not happening - I dont see ...
Hello,is it possible to manually add to collector information about Firepower 2110 (PID - FPR2110-NGFW-K9) and FMC-2500 (Firepower Management Centre)?I tried to scan it via collector and Firepower 2110 was identified as "octeon" device without any de...
Great - thank you very much. According to your info - I was able to setup access to FXOS for FPR2110 and CIMC for FMC and now I have all 3 missing devices at SNTC portal.Thank you again and really appreciate your help.
Hello,same issue here.I tested that from 4 locations (all across the world). I tested following feeds:https://www.perfigo.com/ise/provisioning-update.xmlhttps://www.perfigo.com/ise/posture-update.xmlI can reach the feeds from 1 location but other 3 a...
I already tried that when I was trying to bend the config of OSPF VPN config.
With OSPF neighbor command is following problem:
neighbor 192.168.1.2 ERROR: Neighbor address does not map to any interface
when 192.168.1.2 is IP address of remote end ...
