Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to push software update to FTDs from FMC FMC running 6.6.1 version and same version trying to push on FTD but it gives error message. Pre upgrade validation - snort version on device is out of date. Deploy access control policy from FMC ...
Folks, I am trying to initiate a ping from my FMC Cli but I do not see Ping command available in CLISH mode.. All I see >ConfigureExitShowSystem When type system. Sytem> It will give other options but No Ping, configureexitexpertgenerate-troubles...
Hi All, I am bringing up fabric with APIC version 4.1(1l). some of the leaf we received has older code and I would like to upgrade as stand alone switches/leaf before APIC can discover the leafs. Unfortunately My APIC is unable to discover these leaf...
Hi All, I am trying to ssh and launch ASDM for management IP of ASA. I have ASA with SFR Module. (SFR Module is using mgmt0/0 port for communication, no ip assigned physically on interface and port is connected to management vlan as access , works f...
When I am on corporate wifi I am able to access WEB gui for WLC but when I am connected from home via VPN I am unable to access WLC GUI.. however, I am able to ping from PC(connected to vpn) to WLC management IP. All the GW are on ASA for vpn subnet ...
unfortunately, I am unable to discover the leaf switches via APIC. They are not showing up in controller GUI. That is why I was thinking it is probably IOS version issue.
Thanks for precise answer. We have a basic SVI configured with default gateway, also ISE authentication is enabled on some of the ports(Mab commands). is there any configuration change ? Also you mentioned Rommon upgrade, do I have to use same .bin...
