Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone. I was wondering how configure dot1x on Cisco Catalyst switch and Cisco ACS 5.2, so that Windows 7 users can get access to network. What is the minimal configuration on both Cisco switch and ACS? Thanks
I used some SVI ip address to ssh to cisco switch. After I cteated new management vlan, then set IP address on interface of this vlan and try to connect to this IP address instead of previos IP, some deays appeard between Login/ Password promt and en...
Dear Karthik,Thank you for detailed response. I did this configuration but it seems to me the problem is on ACS side. I get prompt to enter username and password on my Windows PC, I entered them but credentials are not approved and switch port remais...
