Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to make only local hosts to see my snmp trapthe problem right now it can be seen from wan any help snmp-server community public ROsnmp-server community private RWsnmp-server source-interface informs Vlan1snmp-server enable traps syslogsnmp-ser...
but why when I tested the speed without NAT fully speed reached thru ciscoif I routed user from cisco to FTTH modem with static route 192.168.1.10I got 100Mbitis it related vlan and NAT ?
thanks for your quick responseactualy it was R# show int fa2 | i dupl Full-duplex, 100Mb/sI changed to R#sh run int f2Building configuration...Current configuration : 122 bytes!interface FastEthernet2 description Going to Mobily FTTH router switc...
thank you very much it is working now and i can browsing welli have two issue still pendingI need support to forward port 80 HTTP to 192.168.1.222 any packet requested from 192.168.0.10the second issueI am not got the fully speed on my host 192.168.1...
ok i can ping the default gateway for my FTTh router but the problem i am still can not get browse on my host 192.168.1.222the configuration are :ip dhcp pool Wippro import all network 192.168.1.0 255.255.255.0 default-router 192.168.1.254 d...
