Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, I am just wondering if this can be done to build 2 VPN tunnels? If it can be done, how should I set one of it as primary and another one as backup? Router RA====================crypto isakmp policy 1 hash md5 authentication pre-share group 2...
Hi all,I am currently working on some DVR issue. The objective is to allow internet users to access DVR by port forwarding (using http://12.12.12.12:8888).However, I am facing some issues First of all, I tried with this below config. With this config...
Thanks for your guidance Iwen. By the way, say if I use IP SLA with route tracking (pinging public DNS from router RA sourcing the WAN interfaces), and set the cost for default route to 2.2.2.2/29 to be lower. On the other end, set the router RB cry...
Hi Iwen,
Hmm... for this config, there will be 2 tunnels formed for 1 network right? But how is the load sharing/ prioritization be done?
crypto map cm-cryptomap 2 ipsec-isakmp
set peer 2.2.2.2
set peer 3.3.3.3
set transform-set cm-transformse...
Thanks Mike for your advice. But I tried before, not working....I even tried with TCP and UDP port 8554 and 7070 as suggested by some other peoples in other forum.
Thanks Mike again for your adivce. According to the DVR description, RTSP (554) need to be enabled to view the cctv. But I tried with several ways, still not working. Is the configuration below correct ? Or any idea which other ports I need to enable...
