Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings all. We are looking to migrate an 5515-X ASA to ASA on FirePower 2110. There are a few things that are different and I was wondering if anyone had any suggestions on things that have been causing me issues. It was suggested that I could j...
So I've seen in Cisco documentation and on some other places that the Expansion modules on the interconnects can NOT be used as server ports for the chasis?So on a 6296 FI you can only use the fixed ports for downlink/server ports? So that means you ...
Greetings. I know with UCS 2.1 you can plug the FC SAN directly into the fabric without the need for an upstream mds switch for zoning.Can you plug the SAN directly into the interconnect as well as an external host (say some random rackmount server) ...
Are there any caveats with that as far as VPN preshared keys? I'm unclear if the running or startup config has those or if i need to do something special
I have this exact same issue with new M4s I just received. Did you find a solution yet? I'm trying a few things... I found this. The following limitations apply to M3 and M4 board controller firmware:You cannot downgrade the firmware after the upg...
Thank you. I figured this would be the case. I assume it's intention to not be able to zone other devices so that you are required to buy and MDS or 5K to use different hardware.
