Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I setup my 2504 to work with OEAP. When I enabled NAT on the management interface the one AP I have directly connected to the WLC is no longer getting an IP address. Any idea why this is?
I copied my config from my old 5520 to our new 5525 and when I cut over to it from the inside out I could get to the internet no problem but from the outside in none of our access rules were working. Could someone take a look at our config and maybe...
I have main site and site A and B. A connects to main and B connects to main. I can ping from main to A and A to main. I can ping from main to B and B to main. However I can't ping from A to B. A and B are sonicwall 2040's and main is a 5520. T...
Just so you know i only have one AP plugged directly in the WLC becuase there is no POE in this area and the AP sits 5feet from the WLC.I ran the following commands which seem to fix my issues.config ap link-latency disable allconfig network ap-disco...
Yes the one's with the dash '-' at the end is the external IP address. I always thought this was strange as I inherited this setup/config. So the destination in the Access Rules should be the internal address not the external address. Correct?But ...
so my last thing I need to get working and when I had an all sonicwall enviroment all I had to do is enable multicating support on the VPN connections. I'm trying to get appleTV's at all locations to be seen by all iOS devices regardless of location...
ok so this worked. Was it because I was missing the nat (outside,outside) ? I feel thats really the only thing that is diffferent besides seperating everything out?
