Hi,I am using a SG300-10P in L3 mode to power 3 Cisco WAP321s and provide connectivity through a trunk to an ISP-provided broadband router. The switch has been working well except for the DHCP server, which has not been very reliable so far. The DHCP...
Hi,I have two questions about the DHCP server on the SG300:On the Address Binding page, what does the "Declined" state mean? I have a NAS device that won't pull an address, and I think that the entry with a state of "Declined" corresponds to this dev...
Hi,Can the SG300 act as a DHCP server when in L2 mode? I would guess not, but the GUI allows the DHCP server to be enabled while in L2 mode, so I am wondering if thre is a way for this to work.Thanks,Bob
A RV 180 is configured as follows:VLAN 1 and 2 are configured. Inter-VLAN routing and device management is enabled on both VLANs.The SVI for VLAN 1 is 192.168.1.1The SVI for VLAN 2 is 192.168.2.1A SG300 is configured as follows:Layer 3 mode is enable...
When I attempt to configure my RV 180 for remote logging via email I get this error message: Test mail delivery failed I used these settings:Server: smtp.comcast.netPort: 587Authentication: I tried "Password Plain" and "CRAM-MD5"I supplied my email u...
Just to follow-up, I ended up disabling the DHCP server in my SG300 and configuring DHCP relay to a Linux server running dnsmasq. This arrangement has been working without incident for over a month. dnsmasq has a lot of useful features, including the...
I understand that each static address entry has to have a MAC address or a client identifier so that the DHCP server knows who it is talking to. What I don't understand is why I can use a MAC for every device I have tried so far, except for the WAP32...
Hi Tom,Thanks for the quick reply!My second question is about an issue I am seeing with my WAP321. If I statically bind an address to the WAP321's MAC address it will pull a dynamic address rather than the statically assigned one. If I update the sta...
Thanks for the suggestion Richard!The reason I am running the SG300 in Layer 3 mode is because I want it, rather than the RV180, to do all the inter-VLAN routing in my network. I would guess that the SG300 can perform inter-VLAN routing much faster t...