Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Dear all I need to know about cisco RV042 router. I need to know about when I used to login this router via 192.168.1.1 (its edfault getway) then which protocol it uses? TCP or telnet ? and how can I find its parameter through wireshark ?
Regards...
Hello,This is Muhammad Sulaiman Ejaz, I'm CCNA, CCNP r&s. I have training of ASA and MPLS too. I wanna go fo CCIE, I'm here to ask you what CCIE I should go for? Please guide me. Should I go for R&S or SP? I'm was interested in Routing and switching ...
Hi,I want to know what is difference between routing and data transfer? Is routing means to just reach a packet from source to destination, or reply must come back? I mean if we receive a ICMP error then is this still possible that we've done routing...
Hello, Is there any difference between next hop and gateway ? In BGP when we say show ip bgp we get this type of outputRouter# show ip bgpnetwork next-hop metric.........(attributes)I'm learing BGP, when is implement IBGP with EBGP, It made m...
Now can I read parameter (user name and password) by using wireshark ?
I can do this on port 23 (Telnet protocol) which is "unencrypted text communication".
What about 443 port ?
I have attached a picture. please check it.
I have set remote management on 443 port. Now when I am accessing my router then which port and protocol am I using?
Thankyou daniel,let say,R1(se1/0)----(se1/0)R2(se1/1)------(se1/0)R3(se1/1)-------(se1/0)R4(se1/1)now if we ping se1/0 of R4 from R1 and packet also reaches there but don't come back to R1. Is this mean we have completed our routing? or packet must c...
hi,when i types flash_init // it initialize flash thendir flash: //it showed me something like vlan.dat.renamed c3550-ipservic.... vlan.dat config.text.renamed ...
