Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a point to multipoint using 3 1532's.
I have AP "B" setup as the root bridge. AP "A" and "C" are non root bridges.
On "B" I can see the association of the other two bridge AP's in show dot11 association
What is interesting is ...
I am trying to setup a point to multipoint using 3 1532's.
I have AP "B" setup as the root bridge. AP "A" and "C" are non root bridges.
On "B" I can see the association of the other two bridge AP's in show dot11 association
What is interesting is ...
Trying to get contacts imported into Cisco PCA (Cisco Unity Personal Communications Assistant) so we have certain users call by voice command... I am able to get most of the contacts in, but only about 50% will import from Exchange. I cannot figure ...
So after much back and forth with TAC and getting the right people involved, there's a hard limit of 150 on Cisco's side. We are putting in a PER with our partner, but I'm guessing this is a "don't hold your breath" situation Its too bad this isn'...
After updating to 9.1.2 still experiencing the same issue. Whats interesting is they usually end up around 150. One user was 153, another was 152, one of them was 147, and another was right on at 150.
Not yet. However I did find that 9.1.1 (which we are running) does not officially support Exchange 2010 SP3 (which we are on). While most things work, we are going to update to 9.1.2 (which officially supports it) then we will open a TAC case if i...
Same here...Also to note I have "Enable Outbound message logging" off. When that was on I was getting duplicates of both inbound and outbound (so 4 messages for each conversation).Looking at the table, it happens 99% of the time, on occassion there ...
