Between hub and spoke are you running dmvpn or what kid of setup is it. if it is dmvpn eigrp is the recommended protocol to run though ospf can also be used with good design, however in terms of simplicity and sclability eigrp is preffred.

if you are using your spoke backup tunnel for redundancy only and no load sharing is required you can configure below and that should fix the issue for you.To enable one tunnel interface to act as backup to other tunnel interface. You just specify th...

Hello,the best way to do this is update your DNS, however either you can configure NVI nat or can configure NAT hairpinning to make it work with legacy nat.sample config on NATROUTER:interface FastEthernet0/1description "internal interface" ip addres...

Hello Juan,what you se eis expected, IP SLA sends a probe every periodic timer and if that succeds it increases the Number of successes counter by 1.i am not sure what is the issue with it, could you explain what is the issue and what is it that you ...

Hello Pat,I would agree running bgp over bgp would be indeed a good idea and then you can play with attributes to prefer one path over other. ThanksVinod