Hi , i encounter an error shown below while putting the notepad into the cisco router via tftp. The Get file from the router is working but the Put could not work Please help
Hi i've configure my cisco router to receive the SNMP traps if the link goes up or down. However i found out that when i plugged out the cable i'm not receiving any link down on the network management system. Until i plugged in again the link will th...
Hi i would like to do a program using SNMP Traps C#. Example if i plug out a cable from a router or a switch, a prompt will appear in my program showing that "The port has been unplug"Thanks!
Hi i want to read the configuration stored in cisco router without using puTTY or hyper terminal (serial interface) purely using C# and retrieve the configuration files. is this possible?
I could get the config file from the router. I set my router as TFTP server and i use the Get to grab the config file from it. However after i edit what i want i cannot Put back the configuration file into the router.
currently I've a cable that plug to my desktop that is for Internet access. I have a switch and a router. do you have any suggestion on how I can use my desktop to communicate with my Fa0/0 and Fa0/1 and at the same time with Internet access?
Hi i don't quite get your question. my router only has 1 port connected which is the fa0/0 ip address 192.168.1.2 yes, the cable is connected directly to my computer and no other port is connected except the console cable. Message was edited by: Bing...
Hi Reza,all the computers in my lab has AV installed and firewall enabled. I tried the solution you give but could not workI also tried using cross cable to plug the router to my computer also encounter the same error.is there anyway i could check th...
