Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The 2504/3504 WLC supports 802.11k Beacon Reports (Active/Passive/Table), Link Measurement Reports, and Transmit Stream/Category Reports. I enabled these features in the WLC, and using Wireshark, I verified they were enabled in the 'RM Enabled Capab...
Because OKC is not an official standard and is not tested by the Wi-Fi Alliance, I find it causes interoperability issues. I recommend turning OKC off. On the other hand, PMK Caching is an official standard that is a useful feature for non-802.11r ...
What performance level would you like to see? Without 802.11k/r/v enabled (and you are likely not using a CCXv4 client either), when the client roams to a new AP, the client will completely disassociate from the original AP and perform a complete rea...
The setting "key_mgmt=IEEE8021X" in your wpa_supplicant.conf file is for WEP keys only. You mentioned you are using WPA2, so you should use the following: key_mgmt=WPA-EAP Also, if you don't want to be prompted for the private key password, you can ...
As others have pointed out, when the Cisco AP advertises support for both CCXv4 and 802.11k (e.g. Beacon/Neighbor/Link Report capability in RM IE), the client decides which method to use. In our experience, CCX would be used in legacy 802.11 modes ...
