Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OK, the new MAC OS removed PPTP. I now need to figure out how to re-establish a VPN connection.
I am sure someone has solved this... i have tried various combinations of settings between RV220W and MacBook, but can't get connected. I would prefer to...
I have a field office connected to the main office by two RV220W and site-to-site VPN with the latest Firmware.
There is a networked HP printer at the field site (OfficeJet 8610) and I want to print to it from the main office. I can access the prin...
I have two RV220W routers latest firmware, connected via VPN. ISPs are commercial Cable Modem 35M+ download speed. However the traffic over the VPN is only about 2/4M..... Getting about 200ms pings across the VPN...
What can I tweak/look at? If I pa...
OK, I know this was discussed a few years ago but firmware updates may have resolved it.. I have two RV220W at 1.0.6.6 connected via Site-to-Site vpn tunnel... At one site, I have a Windows2008R2 DHCP server at one office that I want to handle DHCP f...
I have a remote office connected to my main office by two RV220Ws. Both are connected to a Cable Modem and obviously connected via VPN. The field site's internal IP is 10.13.200.X and the main site is 10.13.145.X. They are running a client-server bas...
What I need them to do is to report to the DNS server... When the Windows Server is both DHCP and DNS then EVERY DHCP client (Win, OSX, IOS) showed up in DNS. When the RV220 issues DHCP, then only WIN clients show up in DNS.
which is interesting because I have had the scope on the DHCP server set up for a couple of days, and before I turned off DHCP on the 200.1 Router, I saw LEASED ADDRESS in the correct scope some at least ONE request made it across the Tunnel. My issu...
Jeffrey,Most of the research I have read, indicates that the modem should be in bridge mode when using a downstream router and the router should be making the PPPoE connection. I will call defeat but now need the correct router. Also, if I turned off...
I confirmed with TAC that the RV215W can not take a WAN IP address when in PPPoE. That being said. I have now used the NETGEAR to connect to my ISP and then I assigned the ISP provided IP to the NETGEAR LAN port and another of the IP's to the RV215W ...
