Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HerE is a link for you.http://www.cisco.com/en/US/partner/products/hw/switches/ps1938/products_installation_guide_chapter09186a0080080e38.html#xtocid100078As for the PCR or SCR, I would say it would mach the SCR. Note that most of the time PCR and SC...
Here is a link for you, http://www.cisco.com/en/US/partner/products/hw/switches/ps5528/products_configuration_guide_chapter09186a0080509b7e.html#wp1004037I would start with the: Working with the Flash File System section.Displaying Available File Sys...
I would use a EtherChannel, here is a link for you.http://www.cisco.com/en/US/partner/products/hw/switches/ps646/products_configuration_guide_chapter09186a008031ffba.htmlIf you need to have other VLANs than VLAN 1 going over the link, simply make the...
The menmory (DRAM and/or Flash) may have been damaged when the RPS blew up. If you have any other known good memory to test with, this would be the quickest way to see if this is the issue.
Make sure all interfaces in a VLAN are configured for jumbo frames before configuring jumbo frame support on an SVI. A packet’s MTU is not checked on the ingress side of an SVI. However, it is checked on the egress side of an SVI. If the packet’s MTU...
