Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community. I have a need to configure PBR in ACI and hoping someone let me know if this is doable and perhaps point me in the right direction with the configuration. I have two sites I need to forward some traffic flows to a few SDWANs using ...
Hello, I have a quick question with using Inter-VRF multicast with ACI. We have a multicast application that is outside of our ACI fabric. The Receiver is within the ACI Fabric. The L3out to the larger network is associated with a VRF (BLUE VRF) a...
Hi all. My organization's VMWare Team has hypervisors distributed all over our ACI fabric. All the hypervisors have a management network that allows them to communicate with vCenter. Recently (about 2 weeks ago) all the hypervisors started to peri...
Hello Cisco Community. I have what I hope is a basic question with ACI Policy Based Redirection. With ACI can PBR be configured to redirect traffic entering a leaf to a host on another leaf? I have some hosts connected to Leaf switches throughout...
Hello, I may have a problem with TCP resets on the WAVE-7571. I say "may" because I feel the WAAS is probably doing what it is supposed to and I need to just understand why. Scenario Description: We have a scenario with 2 WAN links. On both Lin...
AshSe, While trying to test your recommendations we ran into another issue. I don't believe we were seeing this before but are now. The multicast subscriber IGMP join is showing up at its Leaf, but the PIM join is not making it to the border le...
Remi-Astruc, Thanks a lot for the info. That was exactly what I needed to know. I did get the PBRs working. I used the ESG to break the source network's /24 into two /25s and created an ExtEPG with External Subnets for External networks to rep...
Robert543,Thank you very much for the response. I am confused on how to specify the source and destination IP/Subnet. Is this done using the EPGs? The contracts and its sub-components don't seem to have a place to specify IP addresses only protoco...
AshSe, Thank you for responding to my post. I will try to answer your questions as thoroughly as possible. Please see answer below or next to each question. To better understand your scenario, may I ask you few questions:Frequency and Pattern o...
