Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We were just using VLAN 1 for everything, but now need to segment things better by adding vlans. Our core switch is a Cisco 3850 with Cisco 2960s hanging off of it.
I setup the VLANs and allowed them through all of the trunks. I created the VLAN i...
We just installed a new 3850 as our core switch with some 2960s hanging off it that sit in other buildings in the campus. We were planning on using the 3850 as a wireless controller for the whole campus, but found out that it does...
Ok, so I'm not sure how I go about doing what you've suggested.
10.0.8.1 is the current default gateway on vlan1, its the internal port on the firewall and I don't want to change that IP address.
10.0.8.201 is the 3850 IP address, I would like to mo...
The 3850 wireless controller is already on, that's was the original plan to use it, and it is running a few of the APs right now. I was hoping to leave it running long enough to get the 2504 setup and tested, but it seems that I can't.Is there a wa...
