Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there! I'm stuck on something that should be painfully obvious to me, but I can' t seem to identify it in my config. I am somewhat of a router CLI novice, and haven't mastered ASDM. Note: I've changed around some names and public IP's for secur...
I'm seeking the advice of some experts here. I've got a new Cisco ASA 5505 with the Security+ license, and Cisco L2 switch.I've got 10 VLANs, and want to assign an individual public IP addresses to each VLAN's subnet. The point is --- each of the 10...
Has anyone here tried to mix a Catalyst switch (say, a 3500 or 2950) with a Cisco SG200-26?I've got 4 VLANs setup on a 3500: 1 (default), 10, 20, and 30 I've tried to connect a trunk port (GBIC) out of a 3500, into a SG200, with the hopes of being ...
I've sent you an e-mail to your profile address for the remote session. Not sure if that's the best way to reach you or not. I can ping the host address of vlan 1 externally.
I have applied the commands. Here's the show route: Gateway of last resort is 69.67.62.65 to network 0.0.0.0S* 0.0.0.0 0.0.0.0 [1/0] via 69.67.62.65, outsideC 69.67.62.64 255.255.255.248 is directly connected, outsideL 69.67.62.66 25...