We have set up an independent network for our guest wireless. It is an ADSL modem going into a Cisco 1921. I setup NAT and DHCP on the router and it is only accessible through the wireless connection. We have a 50Mbps connection and about 250 devices...
There are a couple of pieces to this.
First: Your route-map.
The route-map needs the matching conditions. So, you would create an access-list with the routes you want to prepend and then another to allow either all other routes or just the ones yo...
Not sure if this is a change in the past four years, but "Cisco NX-OS supports route leaking (import or export) between VRFs, both in VRF lite and MPLS VPN scenarios. For more information on route leaking, see the Cisco Nexus 7000 Series NX-OS MPLS C...
This is taken directly from the Cisco install and upgrade guide, which is linked below. http://www.cisco.com/c/en/us/td/docs/routers/7200/install_and_upgrade/7201_install_config/7201_icg/11364tr.html Upgrading the Boot Helper (Boot Loader) ImageThe b...
Thank you for the advice and for pointing me to NBAR.I did some research and wanted to share what I came up with on it. (G0/1 is the inside port)!! Creating the class map to identify it!class-map match-any P2Pmatch protocol bittorrent!! Creating the...
