About valsinest

valsinest · 06-23-2020

Hi,I am trying to install APIC on APIC-server from scratch but the installation fails with the following errors: /mnt/source/ifabric.iso: No such file or directorycp: cannot stat `/mnt/sourceiso/insieme/* : No such file or directoryAttempt #2, devic...

valsinest · 08-15-2019

Hi, We have FMC 6.2.3 that is constantly showing high memory utilization. It is installed on VMware with the minimum requirements.It is controlling two ASAs with not much traffic passing through them. Output from top Mem: 7508840k total, 6830632k us...

valsinest · 02-23-2016

Hello all, I am having trouble upgrading Cisco ASA 5505 ios with Cisco Prime 3.0 through the Software Images menu.The device is managed with the Cisco Prime and passes the Upgrade analysis. When i start the deploymentthe upgrade fails with the follow...

valsinest · 06-23-2020

Hi, It is APIC-SERVER-M3 Best regards,

valsinest · 06-23-2020

Hi Sergiu,I got some demo equipment for testing purposes and the APIC server did not have the image installed. If i boot the APIC normally nothing happens so i tried to follow the following procedure and install it. https://www.cisco.com/c/en/us/td/...

valsinest · 01-29-2020

valsinest · 01-28-2020

This might be related to the RFCs: https://tools.ietf.org/html/rfc6052 3.4 The Well-Known Prefix MUST NOT be used for Scenario 3 (the IPv6 Internet to an IPv4 network), as this would lead to using the Well-Known Prefix with non-global ...

valsinest · 01-28-2020

Remove the "ip nat outside" statement from the OSPF interfaces and test again

Member Since	‎10-10-2013 03:25 AM
Date Last Visited	‎01-05-2022 12:07 AM
Posts	11

User Statistics

User Activity

APIC installation issue

High memory utilization FMC

Problem when upgrading Cisco ASA 5505 ios with Cisco Prime 3.0

Re: APIC installation issue

Re: APIC installation issue

Re: Configure Stateful NAT64 with well known prefix

Re: Configure Stateful NAT64 with well known prefix

Re: OSPF "INIT/DROTHER" error