Hello to the Community,
I'm facing a problem trying to establish a wireless mesh between two APs. The BGN is identical between this two APs, backhaul is on the same radio (5GHz), and channel is identical (140).
The root AP receives update from its ch...
Hello,
I'm trying to find any details on the signature embedded in the NBAR2 protocol pack for Wlc. I've seen technical document about update, resolved caveats, opened caveats, but I'm searching for the detail of all the signature. Giving an exam...
The problem is solved. The antenna configuration was not correct (single vs dual). The Root AP has a directionnal antenna (dual mode) but the AP configuration on the Wlc was setup as single. One thing to remember when configuring Mesh and Antenna!
Ha...
yes the APs are already mounted, antenna alignement is OK, and the distance between them is approx 15 meters (1530E mounted outside). The fact is sometime the child AP connects successfully after a longgggggg time and from what i've seen the Mesh bri...
Hi Scott,
Where do i need to put the MAC address? Under AP Auth or macfilter? Do you know also how to remove it from the AP Auth? I did not fond the command.
Thanks
Hi Ric,
Yes, the MAC was already added. So I try to remove it and add it another time but the behaviour is strange:
(Cisco Controller) >config macfilter add 2c:5a:0f:a0:d0:5c 0MAC filter already exists - entry not created.
(Cisco Controller) >config ...