Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As be known that hold ctrl+shift while clicks "help -> about CTC" above the CTC window resulting the debug window occurs.Does anyone know the debug command usage?Since we got a provisioning issue on the 15454-CE card which exists a "hidden" crossconn...
Hello,How to delete "Protect version" of TCC sw on ONS15454?Because just noticing "MEM-LOW" alarm to active TCC card.Btw, is there any concern if deleting prot. sw version ?Ricky
Hi all,Does anybody know how to adjust voltage alarm threshold on ONS 15310 CL, cause it's not available on CTC. And just asking if the function would be available by TL1/Corba?Ricky
Hi,we are implementing ONS 15454 SONET(MSPP) network. And Is there any method to convert a UPSR circuit(VT/STS) to unprotect on ONS15454/15310(Rel 6.0) by using CTC/TL1 without service interruption? Appreciate your expert advice.
Is there anybody who can help to fix problem on downloading "CTM 4.7.0.296.1Patch.tar" from "http://www.cisco.com/cgi-bin/tablebuild.pl/ctm-47", cause the file might be broken.
The official stance of Cisco is that your network can contain 50 nodes or less per CTC session.Kindly refer to the following link:http://www.cisco.com/en/US/customer/products/hw/optical/ps2001/products_tech_note09186a008061ca28.shtml
Hi All,Here's response from CISCO TAC fyr:-------------------------------------------After checking this issue further with developers, here is outcome :* The threshold is not programmable.* It is preset in hardware.* There is no way to change it ...
Hi,It's not working. Actually, I've tried TL1 command "SET-ALMTH-EQPT:::1::BATV-HIGH,-54.5;" on ONS15310, then following with "Invalid Command". Moreover, it's not an available argument to "-ALMTH" following the "SET" command for ONS15310. Thanks any...
Hi all,The conversion would occurs traffic hits up to 2 ES(SES). After DLT and ENT connects, circuits should be reconfigured. If the resulting circuit is a valid circuit, it appears as a DISCOVERED circuit. Otherwise, the circuit appears as a DISCOVE...
