Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two new CPI Hardware Appliances. I have upgraded and installed ver 3.1 on the Primary server and installed the device packs and patches. I have also installed 3.1 on the secondary but because there is no way to reach it via a web browser/GUI, ...
How can I run planning mode in Cisco Prime Infrastructure (maps) with a building that is non-rectangular? It places AP's outside the coverage area. I have also tried excluding the outdoor area on the map.
I have completed the process but not without some hiccups. I had to piece together data from different documents. Basically, there is no information out there on what one can expect during the process and, as I mentioned in the topic, HA 8500 control...
Thank you for your response. The building I am planning for is a U shape with the part in the middle being exterior. We do not want to install outdoor AP's but with the directions you provide I can only change the size of the rectangle, not the shape...
This is the most thorough document I have seen. The documents for 7.4.121.0 code was not as clear. I wish the documentation would give an idea of how long you should expect the process to take given a certain number of access points. Also, I have not...
