Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Router->ASA->routerI configured gre interface in both the router. I could ping gre destination ip from both the router. I could see traffic in my ASA firewall for both gre and Icmp. But my gre interface is still down.I have ASA 5510 wit 8.4 IOSSent f...
Hi. In our office we have a floor switch connected to core switches(vss). There are two up links from floor switch connected to the core. We bundled the two uplink as port channel 5.My question is ,we did power maintenance and shut the floor switch f...
In 8.3 version nat statement depends on object. You need to create object for the source ip as well nat ip and call the object in nat statement.Object network Host/Range/Subnet IP AddressObject network obj-10.10.10.0Subnet 10.10.10.0 255.255.255.0Exi...
Hi harshitMy gre tunnel came up. All I did applied the below command and reset the tunnel config.Default interface tunnel90And I configured the tunnel again. It came up. I configured eigre between the tunnel. I could see the eigrp neighbour.Thanks f...
By default inside to outside permit. Nat is also not required.No specific config in ASAI configured below commentsSysopt connection permit-vpnInspect pptpProvided inbound access for gre and ipSent from Cisco Technical Support Android App
Yes I could see GRE packet between two ip in in inside and outside interface of the firewall.Still the link is up down and configured eigrp I couldn't see neighbour up