Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey folks, I'm having an issue setting up multiple crypto isakmp policies on my 1921 router. Whenever I have only one crypto isakmp policy set up like so:crypto isakmp policy 1 encr aes 256 group 5 It works perfectly fine with my certificate tunnel g...
I have an e4506 enclosure with a Sup 8+ card that I simply can not get to report netflow traffic. I am using the Solarwinds NetFlow Realtime analyzer. My switch configurations are as follows:flow record RECORD1 match ipv4 tos match ipv4 protocol matc...
I'm hoping this will be an easy question.I have a 4506e enclosure in which we've upgraded to a Supervisor 8e card. Is a separate NetFlow hardware module required in order to use NetFlow? I have configured the switch based on what I've found online. f...
Thanks Rich. Actually on both devices pre-shared key authentication is lowest on the priority list for connection. Both devices are "preferring" an rsa-sig authentication. I'm not sure what is doing it, but just by adding the line "authorization pre-...
Thanks for the input Walter. That isn't it though. I have plenty of sites with crypto map <name> 1 which map to crypto isakmp policy 2 settings. The debug is showing that the behavior is to try to authenticate through policy 1 first, and then progres...
Well, I'm not really sure how this got marked as answered. It most certainly is not.I am having the same issue. Every piece of research I have done on this shows that I have the correct settings in the switch, however the Solarwinds analyzer does NOT...
That didn't work either. I'm trying to set it up with netflow v.9.I have a different Cisco device that I have set this up on using the SolarWinds analyzer.It is an 1811 router with the following configuration lines:int fa0 ip route-cache flow!int vla...
I went ahead and tried to all all of the commands to the flow record and here is what I got: switch(config)#flow record RECORD1switch(config-flow-record)# match ipv4 tosswitch(config-flow-record)# match ipv4 protocolswitch(config-flow-record)# match ...
