Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.Just recently added first eXR (asr9901) router to my network. Router came with 6.6.2, and I upgraded it to 6.6.3 before installation on site.Most routers in my network is asr9001 with cXR 6.4.2 and I have a quite good experience with them but e...
But how can I tell which packages should be activated? There is an output of current situation on router:RP/0/RSP0/CPU0:asr#sh install active summaryTue May 19 11:45:45.036 EESTActive Packages: 8asr9k-xr-6.6.3 version=6.6.3 [Boot image]asr9k-k9sec-x6...
What about other packages which are not installed? I must remove them also? So it turns out that for eXR there is no more such concept as Service packs, but so-called "service pack" is just a bunch of SMUs? brAgris
I would recommend to upgrade to v7 if you can.Everything looks ok in your screenshots. I have no much experience with satellite, it is not yet in production in my network.I had the same config but with hostname instead of ip address. At the beginning...
