About rcarroll

rcarroll · 10-16-2006

After erasing the startup-config on a 2811 router, I am unable to get past the "Would you like to enter the initial configuration dialog?" prompt.None of the key strokes issued from my PC have any effect.I have:Tried using a different console cableTr...

rcarroll · 10-22-2003

A PIX will only let a user acces a resource in a DMZ by it's private IP address and not it's public address. I'm sure there is a reason for that that is security-based, but I don't know what it is. Can any one point me to documentation or explain tha...

rcarroll · 10-20-2006

Thanks Rick,I'll give this a try and let you know. I can then post the boot messages, if need be.Roger

rcarroll · 10-17-2006

That sounds like a good idea. I couldn't figure out how to do that without keyboard input.That's what lead me to this site.

rcarroll · 10-17-2006

Thanks for the input. I think I'm not making myself clear, I had just finished erasing the startup config over a console connection and the problem started when I restarted it.

rcarroll · 10-16-2006

That is correct, I get the bootup messages when I power cycle.Nothing happens when I specify yes or no. Nothing at all.I see no bootup messages when I use the aux port.I would agree with your console port diagnosis, if it weren't for the fact that I ...

rcarroll · 10-16-2006

Thanks for the reply Martin,I've already tried a new cable and term program.I can't get to rommon because my keystrokes (in this case, the break sequence) have no effect.

Member Since	‎10-22-2003 10:36 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

Hyperterm to a 2811

Accessing a DMZ from the inside.

Re: Hyperterm to a 2811

Re: Hyperterm to a 2811

Re: Hyperterm to a 2811

Re: Hyperterm to a 2811

Re: Hyperterm to a 2811