Hello, Would you help me with this problem I have an installation with a SPA400+SPA900 and phones 3x SPA942. Country is Czech Republic. Incoming calls shows "Anonymous caller" instead of showing the caller id. I follow some instructions, I have seen, in a documentation that talks about that, but still does not work. I have set up the following configuration on the SPA400 for Czech Republic. Receive Gain:0 Impedance: 270+(750||150nF) Tip/Ring Voltage: 3.5 V Operational Loop Current Min: 10 mA On-hook Speed: 3 ms DC Current Limiting: Enable Caller ID Method 'European (FSK)' Do you have any idea what it could be changed in the config? Thank you for your support Best Regards Pavel Srajer
... View more
Hello All, I have an installation with a SPA400+SPA9000 and phones 3x SPA942 and 1 x SPA921. Country is Czech Republic. Incoming calls shows "Anonymous" instead of showing the caller id. I follow some instructions, I have seen, in a documentation that talks about that, but still does not work. I have set up the following configuration on the SPA400 for Czech Republic. Receive Gain:0 Impedance: 270+(750||150nF) Tip/Ring Voltage: 3.5 V Operational Loop Current Min: 10 mA On-hook Speed: 3 ms DC Current Limiting: Enable Caller ID Method 'European (FSK)' Do you have any idea what it could be changed in the config? Thank you for your HELP. Best Regards Pavel
... View more
