About gabrielblanco1

gabrielblanco1 · 11-27-2013

Hi,I already have VLAN 1 configured with DHCP and NAT/PAT working properly.The router has the WAN port connected to the Internet, and the Fa 0 connected to the LAN.Now I define interface vlan 2 with a new address for a new IP range, and a new DHCP po...

gabrielblanco1 · 11-28-2013

Hi,I tried with static IP address as well. But did not work.Regarding the NAT, I did not get to the point of checking it, since I do not have connection from the router. I cannot ping from the router to the host, and there is no NAT there

gabrielblanco1 · 11-27-2013

Hi,I did check it.I am wondering if it can be done without using two interfaces on the router. However I could try it.I paste here part of my configurationip dhcp pool VLAN network 192.168.132.0 255.255.255.0 default-router 192.168.132.1 dns-se...

gabrielblanco1 · 11-27-2013

Hi and thank you for your answer.That is what I did, but the Router 881 is a bit special and the ports for the LAN connection operate like a switch.I have one port trunking, but the configuration is not like in a router, is like in a switch.And all t...

gabrielblanco1 · 11-27-2013

Hi,I just wonder if it is possible to use the same interface as trunk and skip using one interface for each VLAN.For example:R# conf tR(conf)# int fa 0R(conf-if)# switchport mode trunkR(conf-if)# switchport allowed vlans allWould it work? or is it ne...

Member Since	‎11-27-2013 05:38 AM
Date Last Visited	‎08-18-2017 04:28 AM
Posts	5

User Statistics

User Activity

Configuring several VLANs on a Cisco 881

Configuring several VLANs on a Cisco 881

Configuring several VLANs on a Cisco 881

Configuring several VLANs on a Cisco 881

Configure vlan for cisco 881 router