Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm trying to configure a vpn site2site between ASA5510 and RVW110 router, my architecture is like that:On the central office: the ASA is already connected with other sites trough an ipsec tunnels:Local network 192.168.1.0/24The network betwee...
Hi all,I'am preparing a failover implementation of our ASA 5520, we have two builduing A and B, between them i have onlly one fibre cable available : i will connecte with it a 3750 on each side, and i will use a UTP cable to connect the ASA on a dedi...
Hi,i have a problem for installing this router behind ISP router, pppoe modecan you please tell me how did you connect your router, adressing and routing thank you in advance
I checked the access list it seems ok, please have a look :I attached screen shoots of configuration on both sides.crypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmaccrypto map mymap 1 set transform-set ESP-3DES-MD5access-list outside_1_cry...
hi Sandy,First I want to thank you your answer.on the ASA :show crypto isakmp3 IKE Peer: 81.192.197.30 Type : L2L Role : responder Rekey : no State : MM_ACTIVEsh crypto ipsec sa no information about the tunn...
there is debug on the ASA side, after this negotiation the asa keep responder status and no connection on the router side ASA-5510# May 21 03:45:21 [IKEv1]: IP = 1.1.1.1, IKE_DECODE RECEIVED Message (msgid=0) with payloads : HDR + SA (1) + VENDOR (13...
Hi Julio and thanks for the answer, After more reflexion, I changed the scenario to the new bellow; I decided to place the two asa in the same building since I have a problem with insufficient cables.So, for the new scenario, I used port channels on ...
