Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,I have ISR installed at the site with the below config. How best can I do split tunneling on this ? Right now, it is full tunnel and all traffic is going via tunnel . Current configuration : 14578 bytes!! Last configuration change at 18:21:52...
I am configuring ISR router for voice traffic. Among other requirements, these are the requirements I need advise on :1. Create ACL on router outside interface and block inbound traffic from the internet My commands :ip access-list extended outside_a...
I am configuring 4 x Cisco 2960x - 24PS switches for voice . What details will I need before proceeding with it ?These 4 switches will be connected to 3560 Cisco Catalyst switch. There are about approx 60 users .What is the best way to do this ?
Hi , I want to stop traffic from one of my port using Mac acl. I captures frames on wireshark and they are STP and LOOPBACK related. I believe Mac acl is used to stop Non ipv4 traffic which is STP etc.. i am using cisco 2960 mac access-list extended ...
@paul driver Thanks for your reply. I am not sure I understand what you are saying. How do I route traffic such that private IPs go via tunnel and the rest of the traffic through the outside interface ? Thank you.
Thanks for response.I need only private IPs to go through tunnel 5 and rest of the traffic via Primary ISP interface. if the primary interface goes down then there is backup ISP interface. Right now, as you can see there is default route for all tra...
Hi @Georg Pauwen My mistake, Apologies , I copied the wrong router config .Please see existing config with full tunnel - Current configuration : 14578 bytes!! Last configuration change at 18:21:52 EST Wed Jul 29 2020 by ! NVRAM config last updated at...
Hello @Georg Pauwen Thank you for all your help. I am on the last phase of implementation.I have configured the router with zone based firewall and I understand now that we need this for stateful filtering .Now, after configuring , I checked with co...
Hello @Georg Pauwen Thank you for your response. Please find my answers. 1. The DHCP IP range is 10.10.18.0/24 for phones and they will be on vlan18 . Gateway for phones will be 10.10.18.253 I believe this should be applied on interface vlan 18, ip...
