Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running into an issue where the IPS is not pingable from the gateway (switch) or internal network, but the IPS is able to ping other networks. For example:I had the ASA configured according to the Cisco recommendation of configuring the managemen...
So I'm trying to do a simple test in a lab environment but can't seem to understand why the syntax for NAT statements is not working in 9.x. Here is an example:ASA: outside ip 99.99.99.99/29 inside ip 192.168.4.1/24NAT outside ip 99.99.99.100 to ...
I have built a lab at home. I have a Win2008 Server for AD/DNS, ISE 1.2 (VM trial), a 3560-cg switch, 2500 WLC and 2602i AP. I have configured everything as per the documentations online. My issue is that when I connect to the open SSID, it gets conn...
Had the same issue. Followed the instructions on how to edit in VI then pasted the attached sftunnel.conf and saved. Module registered instantly. Thanks
I have a similar problem. I can ping from the IPS, the L3 gateway (VLAN on switch) and all other networks. However, I cannot ping the IPS ip from any other device.So my configuration is as follows:int g0/0nameif insidesecurity-level 100ip add 10.10.1...
Thanks I tested both with the object and just the ip and it works for both. One more thing, the configuration that I was using was from an 8.2 code and using the same ASA migrated it to 8.3 which migrated these NAT rules. I know a lot of people have ...
