Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am setting up a new network that will include at least 3 but as many as 6 WAP321 Wireless Access Points.I used the wizard to set them up and all seemed well. I then went in to see how effective they were and discovered that the only differenc...
Hello,I am converting all of the switches here, about 150, form TACACS to RADIUS. The reason is that we are going to ISE which not compatible with TACACS.The problem I ran into was that when I appiled the RADIUS config to some of the 3850 switches (w...
I am going through a 2 year degree course for Network Design and Adminstration and I have an internship with the city I live in. I have been tasked to reconfigure over 150 layer 3 switches (all Cisco and ranging from 2960, 3560 to 3850 [the 3850...
Javier,The RADIUS server and TACACS are the same unit. We use Cisco appliances and to change from TACACS to RADIUS is done with a config change there using ACS and also the device that will authenticate too it. Every switch and router we have authent...
Okay that make sense as far as it goes but help my addled brain... why would I want to send attributes to the user or admin after the authentication? It sounds redundant since it is done at the time of the authentication.
