Dear,
I'm install Cisco Collector 2.7 over Hyper-V environment, but no conection Cisco Backend.
When run collect and upload this result is failed.
Please , could send firewall port to access cisco backend and command test connectivity.
Thank
Rega...
Dears,I'm install CSPC 2.7 ISO on Hyper-V. at finish installation deploy certified and web browser access.But CLI access don´t newly. the user account "admin" is locked. I wait 30 minutes however don´t access CLI.I need access CLI to test connectivi...
Hi everyone.I replace a switch leaf and these switch is registered on a lot NMS. It's possible keep the before ip address that el switch issue have.Actually, the leaf switches have DHCP IP address. Please, hope your comments. Thank you.
thanks Cesar,I do it.But, No succed.[collectorlogin@CSPC-Antamina ~]$ chmod a+r transport-inventory-CSP0009031021-1506628346890.zipchmod: changing permissions of `transport-inventory-CSP0009031021-1506628346890.zip': Operation not permittedconstantly...
dear,I intent procedure below, but when WinSCP execute, not access permit using user collectorlogin.is possible right permission edit? or intent with user root? please your comments.Best regards
